• Your shopping cart is empty!

CXRacing Intercooler Piping Pipe Tube + Cold Air Intake + Radiator Fan Shroud + 12" Fans Kit For 1983-1990 Land Rover Defender 90 and 110, 2.5L Turbo Diesel
　
Factory Turbo Diesel Defender Does NOT Come with Intercooler, This Intercooler Setup Is An Addition to the Turbo System, Lowers Intake Air Temperature, Increases Power.
　
This Setup Needs to Remove Stock Clutch Fan to Fit the Intercooler and Piping. Kit Comes with Radiator Shroud and Fans That Fit Stock Radiator, Replace Stock Fan and Fan Shroud with New Electrical Fans and Aluminum Shroud, Clears A Lot Of Front Room for Intercooler. Bolt On Fitment.

Note: This Shroud ONLY Fits Full Size Radiator, Does NOT Fit Shorter Radiator that Used with 300 TDI Engine.
　
This is CXRacing's Newest Product for The Application Stated. All Products Are Developed from The Ground up in Our R&D Center Based in The USA. Our Parts Are Designed and Built for Improved Performance Gains, with Excellent Fitment and Ease of Installation.

Application(s):
- Chassis: Land Rover Defender 90 and 110
- Motor: 2.5L Diesel Turbo

PRODUCT(S):
- Aluminum Intercooler, with Mounting Brackets x1
- Aluminum Piping Kit x1
- Set of Silicon Hose (Blue or Black) x1
- Set of T-bolt Clamp x1
- Air Filter x1
- Fan Shroud x1
- 12" Fan x2



Installed Photos:

























Write a review

Please login or register to review

Intercooler Piping Pipe Tube Intake Radiator Fan Shroud Kit For Land Rover Defender 2.5 90 110

  • Brand: CXRacing
  • Product Code: KIT-25TD-STOCK-IC-FAN-DEFENDER
  • Availability: In Stock

  • $635.45

Available Options


0 reviews / Write a review

Tags: CXRacing Intercooler Piping Pipe Tube + Cold Air Intake + Radiator Fan Shroud + 12" Fans Kit For 1983-1990 Land Rover Defender 90 and 110, 2.5L Turbo Diesel 　 Factory Turbo Diesel Defender Does NOT Come with Intercooler, This Intercooler Setup Is An Addition to the Turbo System, Lowers Intake Air Temperature, Increases Power. 　 This Setup Needs to Remove Stock Clutch Fan to Fit the Intercooler and Piping. Kit Comes with Radiator Shroud and Fans That Fit Stock Radiator, Replace Stock Fan and Fan Shroud with New Electrical Fans and Aluminum Shroud, Clears A Lot Of Front Room for Intercooler. Bolt On Fitment.



Emission Notes:

All Parts and services offered by CX-GARAGE are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CX-GARAGE assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CX-GARAGE products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.