Factory Intake Elbow is Extremely Restricted, The Smallest Area is
Only Approximate 1.5" (See Pictures Below). With Our 3" Pipe, It
Completely Removes The Restriction, Improve Performance by Lowering
EGT Between 200-300 F Deg.
Product Being Sold:
Intake Pipe + Hose + Clamps
This is a New Intake Elbow Pipe Developed By CXRacing From Ground
Up.
To Replace Restricted Factory Intake Elbow with Mandrel Bent Pipe
Offers Better Flow Radius.
Connects to Factory Intake Heater Flange.
Product Info and Spec:
- Piping Kit:
Mandrel Bent Aluminum Pipe
3" Turbo Intake pipe
Comes with Silicon Hose, and T-Bolt Clamps
It is illegal to sell, install, or offer for sale any aftermarket part that alters or modifies the original design or performance of the motor vehicle pollution control system. Product(s) listed here is(are) solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for use on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).
All Products by CX-GARAGE are solely for Competition Vehicles(race vehicles) that are for Off-Road, Track Racing ONLY. All parts are for used on a vehicle that will NEVER be used, or licensed, or registered for use upon a street and highway. DO NOT Purchase the part(s) if you are intending to use it(them) on a Street/Highway vehicle(s).
Proposition 65 Warning:
These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.
This website uses cookies. We do this to better understand how visitors use our site and to offer you a more personal experience. We share information about your use of our site with social media and analytics partners in according with our Privacy Notice.
By clicking any link on this page you are giving your consent for us to set cookies.