• Your shopping cart is empty!

CXRacing Single Top Mount Turbo Manifold For 1993-2002 Toyota Supra MK4 With 2JZ-GTE Turbo Engine Single Turbo

Fits GS300 with 2JZ-GTE Swap.

Fits IS300 with 2JZ-GTE Swap(GT35 or Smaller Turbo),

Larger than GT35 will need to relocate ABS Unit.

Bolt On Fit, CXRACING's NEWLY Released Manifold, Fully Tested.

Completely Developed From Ground Up, All Parts Fit Perfectly.

11 Gauge Thick Wall 304 Stainless Steel Manifold, Won't Crack.

New Manifold Design, Move Turbo Towards to the Front, Equal Length Top Mount T4. Offers More Room for WG and DP.

Laser Cut Flange.

Fit T4 3" Vband Exhaust Outlet Turbo (like T67, T70, T72, T76).

Wastegate Flange is 44mm Vband.

Note:
This Auction is For the Manifold ONLY, All Other Parts Shown Are NOT Included. We do Offer the Complete Kit, Please Check Our Other Products.

This Product was developed based on US model Left-Hand-Drive chassis. For Right-Hand-Drive, due to potential conflict with steering shaft, fitment most likely will be an issue and we don’t guarantee fitment. Modification is needed and we won’t accept return due to Right-Hand-Drive fitment issues.
　 　 　 　 　 　 　 　 　 　 　
Installed on an IS300 Swap:
　 　

Write a review

Please login or register to review

T4 Single Top Mount Turbo Manifold For 2JZGTE 2JZ-GTE IS300 GS300 Supra

  • Brand: CXRacing
  • Product Code: MF-2JZGTE-WT-N-IS300
  • Availability: In Stock

  • $769.05


0 reviews / Write a review

Tags: CXRacing Single Top Mount Turbo Manifold For 1993-2002 Toyota Supra MK4 With 2JZ-GTE Turbo Engine Single Turbo Fits GS300 with 2JZ-GTE Swap. Fits IS300 with 2JZ-GTE Swap(GT35 or Smaller Turbo), Larger than GT35 will need to relocate ABS Unit. Bolt On Fit, CXRACING's NEWLY Released Manifold, Fully Tested. Completely Developed From Ground Up, All Parts Fit Perfectly. 11 Gauge Thick Wall 304 Stainless Steel Manifold, Won't Crack. New Manifold Design, Move Turbo Towards to the Front, Equal Length Top Mount T4. Offers More Room for WG and DP. Laser Cut Flange. Fit T4 3" Vband Exhaust Outlet Turbo (like T67, T70, T72, T76). Wastegate Flange is 44mm Vband.



Emission Notes:

All Parts and services offered by CX-GARAGE are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CX-GARAGE assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CX-GARAGE products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.