• Your shopping cart is empty!

CXRacing Chromoly Cylinder Head Stud for 1996-2003 GM/Chevy LS/LM/LQ Engines

Fits LS1, LS2, LS3, LS6, LS7, LQ4, LQ9. LM4, LM7, 4.8L, 5.3L, 5.7L, 6.0L, 6.2L, 7.0L

This Item is ONLY for One Stud, It Is the Medium Length Bolt (130mm Length, ONLY Needed for 1996-2003 Engines)

Features:

- 220,000 PSI Strength
- 12 Point Nuts, with Washers
- Black Oxide Finish
- M11 x 130mm Stud (at the Front and Rear of Each Cylinder Head)

These Cylinder Head Studs Are Made With High Quality Chromoly Steel, Hold Extreme Strength for High Power Engine Builts, Such As Boosted Applications.

Note: This Stud Does NOT Fit 2004+ Model of Engines, Which Have All Long M11 Studs. But We Also Carry These Studs, Please Check Our Other Items.

Recommended Torque Spec: 70 lb/ft

Item(s) Included:
- Medium Length M11 Stud x1
- Nut and Washer x1

Installed Picture(s):




















Write a review

Please login or register to review

Head Stud for LS/LM/LQ Engine LS1 LS3 LQ9 5.3L 5.7L 6.0L Med Length

  • Brand: CXRacing
  • Product Code: BOLT-L1-M
  • Availability: In Stock

  • $13.48


0 reviews / Write a review

Tags: CXRacing Chromoly Cylinder Head Stud for 1996-2003 GM/Chevy LS/LM/LQ Engines Fits LS1, LS2, LS3, LS6, LS7, LQ4, LQ9. LM4, LM7, 4.8L, 5.3L, 5.7L, 6.0L, 6.2L, 7.0L This Item is ONLY for One Stud, It Is the Medium Length Bolt (130mm Length, ONLY Needed for 1996-2003 Engines) Features: - 220, 000 PSI Strength - 12 Point Nuts, with Washers - Black Oxide Finish - M11 x 130mm Stud (at the Front and Rear of Each Cylinder Head) These Cylinder Head Studs Are Made With High Quality Chromoly Steel, Hold Extreme Strength for High Power Engine Builts, Such As Boosted Applications. Note: This Stud Does NOT Fit 2004+ Model of Engines, Which Have All Long M11 Studs. But We Also Carry These Studs, Please Check Our Other Items. Recommended Torque Spec: 70 lb/ft



Emission Notes:

All Parts and services offered by CX-GARAGE are for competition vehicles only. Use on State and Federal Highways may be a violation of the EPA Clean Air Act. The Clean Air Act can be found at http://www.epa.gov/air/caa/. This document contains in detail what are considered to be violations of the CAA and corresponding penalties for failure to obey and should be read in full before purchasing or installing this competition use only product. Ensuring that all emissions, noise/sound, and speed/use related laws are followed is the responsibility of the Buyer(s). Installation and use of this product indicates that this disclaimer has been read, acknowledged, and understood fully by both the Buyer(s) and Installer(s). The Buyer(s) assumes all associated risk of the purchase.

Federal and several state laws prohibit the removal, modification or rendering inoperative of any part that affects emissions or safety on motor vehicles used on public streets or highways. CX-GARAGE assumes no liability for any violations arising out of any federal, state or provincial emissions or safety requirements on motor vehicles arising out of the customer’s modifications and/or use of CX-GARAGE products. It is the responsibility of the customer to determine if their modified vehicle complies with applicable laws.
Proposition 65 Warning:

These products may contain chemicals known to the State of California to cause birth defects or other reproductive harm. For more information visit www.P65Warnings.ca.gov.